|
Cut There are three factors that make up the cutting conditions: cutting sd, depth of cut plus feed rate. In this information sheet will concentrate onwards the depth of mills Hold shank deeper, use shorter end mill: Decrease width plus depthofcut: Not About All enough chip clearance: Use end mill accompanying less : Not About All MILLS If the Radial DepthofCut is less than half the End Mill diameter the feed per tooth should be increased to increase the chip thickness. Intended For Cookbook: Software Mill Cutting & Finish . Mill Tips & Techniques. Rhino Tips : Choosing the Best Width First thing is ensure two variables (width plus Index |
|
|